There are two distinct ways to cut materials when milling: Conventional Milling (Up) and Climb Milling (Down). The difference between these two techniques is the relationship of the rotation of the cutter to the direction of feed. In Conventional Milling, the cutter rotates against the direction of the feed. During Climb Milling, the cutter rotates with the feed.
Conventional Milling is the traditional approach when cutting because the backlash, or the play between the lead screw and the nut in the machine table, is eliminated (Figure 1). Recently, however, Climb Milling has been recognized as the preferred way to approach a workpiece since most machines today compensate for backlash or have a backlash eliminator.
Chip width starts from zero and increases which causes more heat to diffuse into the workpiece and produces work hardening
Tool rubs more at the beginning of the cut causing faster tool wear and decreasing tool life
Chips are carried upward by the tooth and fall in front of the cutter creating a marred finish and re-cutting of chips
Upwards forces created in horizontal milling* tend to lift the workpiece, more intricate and expansive work holdings are needed to lessen the lift created*
Chip width starts from maximum and decreases so heat generated will more likely transfer to the chip
Creates a cleaner shear plane which causes the tool to rub less and increases tool life
Chips are removed behind the cutter which reduces the chance of recutting
Downwards forces in horizontal milling are created that help hold the workpiece down, less complex work holdings are needed when coupled with these forces
Horizontal milling is when the centerline of the tool is parallel to the workpiece
climb milling
When to Choose Conventional or Climb Milling
Climb Milling is generally the best way to machine parts today since it reduces the load from the cutting edge, leaves a better surface finish, and improves tool life. During Conventional Milling, the cutter tends to dig into the workpiece and may cause the part to be cut out of tolerance.
However, though Climb Milling is the preferred way to machine parts, there are times when Conventional Milling is the necessary milling style. One such example is if your machine does not counteract backlash. In this case, Conventional Milling should be implemented. In addition, this style should also be utilized on casting, forgings, or when the part is case hardened (since the cut begins under the surface of the material).
Comments